View IR6210_356681.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

Data Sheet 60055-I (NOTE: For new designs, we recommend IR's new products IPS511 and IPS511S)
IR6210
INTELLIGENT HIGH SIDE MOSFET POWER SWITCH
Features
* * * * * * * * * *
PWM current limit for short circuit protection Over-temperature protection Active output negative clamp Reverse battery protection for logic circuit Broken ground protection Short to Vcc protection Low noise charge pump Sleep mode supply current 4kV ESD protection on all leads Logic ground isolated from power ground
Product summary Vcc(op) 5-50V RDS(on) Ilim Tj(sd) Eav Applications 200m 5A 170oC 100mJ
General Description
The IR6210 is a 5 terminal monolithic high side switch with built in short circuit, over- temperature, ESD protections, inductive load turn off capability and diagnostic feedback. The on-chip protection circuit goes into PWM mode, limiting the average current during short circuit if the drain current exceeds 5A. The protection circuit latches off the high side switch if the junction temperature exceeds 170oC and latches on after the junction temperature falls by 10oC. The Vcc (drain) to out (source) voltage is actively clamped at 55V, improving its performance during turn off with inductive loads. The on-chip charge pump high side driver stage is floating and referenced to the source of the Power MOSFET. Thus the logic to power ground isolation can be as high as 50V. This allows operation with larger offset as well as controlling the switch during load energy recirculation or regeneration. A diagnostic pin is provided for status feedback of short circuit, over temperature and open load detection.
* Solenoid driver * Programmable logic controller
Truth Table
Condition Normal Normal Output Open Output Open Shorted Output Out In H H L L H H H L H Current-Limiting
PWM Mode
Dg H L H H L L L L
L Shorted Output Over-Temperature H Over-Temperature L
L L L
Block Diagram
Vcc
Packages
5 Lead SMD220
5 Lead TO-220
GND OUT
www.irf.com
1
IR6210
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. (TC = 25oC unless otherwise specified.) Symbol
Vcc
Parameter
Supply voltage permanent reverse Logic to power ground offset Input voltage Input current Output voltage Output current Diagnostic output voltage Diagnostic output current Repetitive avalanche energy Electrostatic discharge (Human Body Model) Electrostatic discharge (Machine Model) Power dissipation Operating junction temperature range Storage temperature range Lead temperature (soldering, 10 seconds)
Min.
-0.3 -16 Vcc -50 -0.3 -- Vcc -50 -- -0.3 -- -- -- -- -- -40 -40 --
Max.
50 -- Vcc +0.3 30 10 Vcc +0.3
self-limited
Units
V mA V A V mA mJ V V W
o
Test Conditions
For 10 seconds, (1)
Voffset Vin Iin Vout Iout Vdg Idg Eav ESD1 ESD2 PD TJop TStg TL NOTES: (1) with 15k resistors in input and diagnostic
30 10 100 4000 1000 28 150 150 300
I = 2A (2) C = 100 pF,R = 1500 C = 200 pF, R = 0 Tcase= 25oC
C
(2) maximum frequency depends on heatsink (rectangular waveform)
Static Electrical Characteristics
(TC= 25C unless otherwise specified.) Symbol Parameter
Vccop Iccoff Iccon Iccac Vih Vil Ilon Iloff Ioh Iol Vdgl Idgh RDS(on) Operating voltage range Sleep mode supply current Supply current (average) Supply current (AC RMS) High level input threshold voltage Low level input threshold voltage On-state input current Off-state input current Output leakage current Output leakage current Low level diagnostic output voltage Diagnostic output leakage current On-state resistance
Min.
5 -- -- -- -- 1 10 1 -- 0 -- 0 -- --
Typ.
-- 40 3 20 2 1.8 -- -- 20 -- 0.3 -- 150 200
Max. Units Test Conditions
35 -- -- -- 2.5 -- 70 30 -- 10 -- 10 200 -- V A mA A V Vin = 3.5V Vin = 0.4V Vout = 6V Vout = 0V Idg = 1.6mA Vdg = 5V Iout = 1A Vcc = 5V, Iout = 1A Vcc=24V, Vin= 0V Vin = 5V Vin = 5V
A
V A m
2
ww.irf.com
IR6210
Switching Electrical Characteristics
(VCC = 14V, resistive load (RL) = 12, TC= 25C.) Symbol Parameter
tc Dc ton t off dv/dt on dv/dt off Over-current cycle time Over-current duty cycle Turn-on delay time to 90% Turn-off delay time to 10% Slew rate on Slew rate off
Min.
-- -- -- -- -- --
Typ.
5 10 50 60 3 5
Max. Units Test Conditions
-- -- -- -- -- -- ms % s V/ s
Protection Characteristics
Symbol Parameter
Ilim Vsc Vslh Vcl1 Vcl2 Internal current limit Short circuit detection voltage Open load detection voltage Output negative clamp Output negative clamp
Min.
-- -- -- 50 --
Typ.
5 3.5 3.5 54 56
Max.
-- -- -- -- 62
Units Test Conditions
) V Iout = 10mA Iout = 2A
Thermal Characteristics
Symbol Parameter
Tjsd Thys Rthjc Rthja Thermal shutdown temperature Thermal hysteresis Thermal resistance,junction to case Thermal resistance, junction to ambient
Min.
-- -- -- --
Typ.
170 10 3.5 50
Max. Units Test Conditions
-- -- -- --
o
C
o
C/W
Lead Assignments
3 (Vcc) 3 (Vcc) 1 - Ground 2 - In 3 - Vcc 4 - DG 5 - Out
12345
12345
5 Lead - TO-220 IR6210 Part Number
www.irf.com
5 Lead - D2PAK (SMD220) IR6210S
3
IR6210
Case Outline 5 Lead - TO-220
IRGB 01-3042 01
Tape & Reel 5 Lead - D2PAK (SMD220)
01-3071 00 / 01-3072 00
4
ww.irf.com
IR6210
Case Outline 5 Lead - SMD220 (D2PAK)
3
01-3066 00
IR WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245 Tel: (310) 252-7105 IR EUROPEAN REGIONAL CENTRE: 439/445 Godstone Rd, Whyteleafe, Surrey CR3 0BL, United Kingdom Tel: ++44 (0) 20 8645 8000 IR JAPAN: K&H Bldg., 2F, 30-4 Nishi-Ikebukuro 3-Chome, Toshima-Ku, Tokyo, Japan 171-0021 Tel: 81 (0) 33 983 0086 IR HONG KONG: Unit 308, #F, New East Ocean Centre, No. 9 Science Museum Road, Tsimshatsui East, Kowloon, Hong Kong Tel: (852) 2803-7380 Data and specifications subject to change without notice. 3/28/2000
www.irf.com
5

▲Up To Search▲

Price & Availability of IR6210

	To Download IR6210 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .